Propellerhead Reason Especificações descarregar pdf (Página 15)

USING

Connecting Propellerhead Balance to an amplification

system

! Before connecting audio cables between Propellerhead Balance and an amplifier+speaker system, or

powered monitor speakers, make sure the Main Out Level knob on the Propellerhead Balance audio interface

is set to a low value and that the volume on your amplifier/powered monitors are set to a low value. Loud

volumes could cause hearing damage!

The Main Out Level knob

1. Connect a balanced (TRS) or unbalanced (TS) 1/4” plug cable between the Left Out of the Propellerhead

Balance audio interface and the left input of your amplifier/powered monitor speaker.

Connecting powered monitor speakers

The Main Out jacks of the Propellerhead Balance interface are balanced for a minimum of noise sensitivity.

However, you can connect unbalanced cables to these as well - it won’t damage the interface.

2. Connect another cable between the Right Out and the right input of your amplifier/powered monitor speaker.

3. Adjust the volume by turning up the Main Out Level knob.

The Main Out Level knob

D You might also need to adjust the volume on your amplifier/powered speakers.

! Before switching off your computer with the Propellerhead Balance interface connected, be sure to switch off

or turn down the volume completely on your amplifier/powered monitor speakers to avoid loud pops!

Right

Left

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Sem comentários

Propellerhead Reason Especificações Página 15