Propellerhead Reason - 1.0.1 Manual de Operações descarregar pdf (Página 161)

THE EFFECT DEVICES

159

RV-7 Digital Reverb

Reverb adds ambience and creates a space effect. Normally, reverb simu-

lates some kind of acoustic environment such as a room or a hall, but you

could also use it as a special effect.

➜ The Reverb device can be used as a send effect or an insert effect.

If several devices uses the same type of reverb, you should connect the

reverb as a send effect, to conserve computer power.

Parameters

The display to the left on the panel shows the selected reverb algorithm - the

general type of reverb. By clicking the arrow buttons you can change algo-

rithm, with the following options available:

✪ If you need to conserve computer power, try using the Low Density

algorithm. This uses much less power than the other algorithms.

The selected reverb algorithm can be tweaked using the parameters on the

device panel:

CV Inputs

You can control the Decay parameter via the CV input on the back of the Re-

verb device.

Algorithm

Description

Hall Emulates a fairly large, smooth hall.

Large Hall Emulates a larger hall, with pronounced pre-delay.

Hall 2 A hall reverb with a brighter attack than “Hall”.

Large Room Emulates a large room with hard early reflections.

Medium Room Emulates a medium-sized room with semi-hard walls.

Small Room A smaller room, suitable for “drum booth”-type reverbs.

Gated A gated reverb, that is abruptly cut off.

Low Density A thinly spaced reverb, where you clearly can here the in-

dividual echoes. Useful for strings and pads and as a spe-

cial effect.

Stereo Echoes An echo effect with the repeats alternating between ste-

reo sides.

Pan Room This is slightly similar to “Stereo Echoes”, but the echo re-

peats have soft attacks.

Parameter

Description

Size Adjusts the emulated room size. Middle position (value 0) is

the default size for the selected algorithm.

Lowering this parameter results in a closer and gradually

more “canned” sound. Raising this parameter results in a

more spacey sound, with longer pre-delay.

For the “Stereo Echoes” and “Pan Room” algorithms, the

Size parameter adjusts the delay time.

Decay This governs the length of the reverb effect. Middle position

is the default decay time for the selected algorithm.

Note: Decay is not used for the “Gated” algorithm.

Damp Raising the Damp value cuts off the high frequencies of the

reverb, thereby creating a smoother, warmer effect.

Dry/Wet If you are using the reverb as an insert effect, you use this

parameter to adjust the balance between the unprocessed

audio signal (dry) and the effect (wet).

If the reverb is used as a send effect, this should be set all

the way to wet only, since you can control the balance by us-

ing the AUX send controls in the Mixer.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 206 207

Comentários a estes Manuais

Sem comentários

Propellerhead Reason - 1.0.1 Manual de Operações Página 161

Comentários a estes Manuais

Manuais e produtos relacionados com Software Propellerhead Reason - 1.0.1